Plate magnets
Title | ||
---|---|---|
Title | ||
Plate magnets are used for removing ferrous materials from material flows on conveyor belts, during free-fall, in vertical or sloping pipelines, under chutes and slides, etc.This type of plate magnet is fitted with powerful ceramic magnets mounted in such a way that an extra strong, deep magnetic field is generated (see table). The surfaces of the magnet that can come in contact with the material flow are made of stainless steel (AISI 304). This type of plate magnet is fitted with a steel plate on the rear with threaded holes for installation. The standard range includes magnets in a large number of different sizes - almost any size can be supplied on order. To make cleaning the plate magnets quick and thorough, they can be supplied with a cleaning tray which can be either manually or pneumatically operated. The pneumatic operation could be used to advantage when the magnet is installed in a position that is difficult to reach. The pneumatic operation meets all ISO and CETOP standards. | ![]() | Plate magnets type FDA - with ferrite magnet systems |
Plate magnets are used for removing ferrous materials from material flows on conveyor belts, during free-fall, in vertical or sloping pipelines, under chutes and slides, etc.Plate magnets equipped with these powerful Neodymium magnetic material are used when a relatively large depth of magnetic field is needed. This can be the case, for example, when very small ferrous particles (< 5 μ) have to be separated from material flows. | ![]() | Plate magnets type FDA - with Neodymium magnet systems |
This type of bar magnet is normally used to remove ferrous particles from raw materials during textileproduction. | ![]() | Bar magnet - Neodymium type FDB |
FDL type plate magnets are used for separating iron from less severely contaminated materials. To ensure a robust construction and flexible mounting possibilities, this type of magnet is built with a steel omega profile.<br />This means the magnets also have flanges on which hinges or locks can be mounted. The surface that comes in contact with the material flow is wear resistant. On special order, the magnets can also be supplied with a stainless steel cover for the magnetic surface. The FDL type plate magnets can be supplied in three models:<b><br />FDL:</b> flat plate magnet<br /><b>FDL/C:</b> plate magnet with inclined pole so that the ferrous particles are collected behind the raised<br />edge of the pole<b><br />FDL/V:</b> plate magnet equipped with 'fingers' to give an especially thorough separation of ferrous<br />particles<br />The standard range of FDL plate magnets can be supplied in a large number of different sizes.<br />However, almost any length and width is available on special order. | ![]() | Plate magnets, type FDL, FDL/C, FDL/V |